You will see the Proxy server settings here.If your system uses a proxy server and you wish to remove it, open an elevated command prompt, type the following command, and then press Enter:This will remove a proxy server and configure “direct access” to the Internet. However, if the connectivity check results indicate a failure, an HTTP error is displayed (see HTTP Status Codes). In general, WinHTTP specifies the proxy and proxy bypass servers on a per-session basis when the session is created. netsh winhttp … It is replaced by the Netsh.exe winhttp commands. You have to make use of the built-in netsh.exe tool in your Windows operating … The WinHTTP version 5.1 API can retrieve and use these proxy settings. To use the same proxy configuration as WinINet or IE, the WinHTTP client should set proxy settings for the session. To reset the winhttp proxy, enter the following command and press Enter. Öffnen Sie eine Befehlszeile mit erhöhten Rechten: a. Wechseln Sie zu Start, und geben Sie cmd ein. For example: netsh winhttp set proxy 10.0.0.6:8080. … The Microsoft Defender ATP sensor requires Microsoft Windows HTTP (WinHTTP) to report sensor data and communicate with the Microsoft Defender ATP service.The embedded Microsoft Defender ATP sensor runs in system context using the LocalSystem account. To Configure the proxy for WinHTTP Services, run the following command in a Command Prompt window that has elevated permissions: netsh winhttp set proxy "---" Note In this command, replace the three hyphens (---) with the following text, including the appropriate values for the placeholders: The group policy can be found under:To reset the winhttp proxy, enter the following command and press If a proxy or firewall is blocking all traffic by default and allowing only specific domains through, add the domains listed in the downloadable sheet to the allowed domains list.If a proxy or firewall has HTTPS scanning (SSL inspection) enabled, exclude the domains listed below from HTTPS scanning.settings-win.data.microsoft.com is only needed if you have Windows 10 devices running version 1803 or earlier.URLs that include v20 in them are only needed if you have Windows 10 devices running version 1803 or later. For more information on Microsoft Defender ATP URL exclusions in the proxy, see Configure a registry-based static proxy to allow only Microsoft Defender ATP sensor to report diagnostic data and communicate with Microsoft Defender ATP services if a computer is not be permitted to connect to the Internet.The static proxy is configurable through Group Policy (GP). netsh winhttp reset proxy See Netsh Command Syntax, Contexts, and Formatting to learn more. For more information, see The WinHTTP configuration setting is independent of the Windows Internet (WinINet) Internet browsing proxy settings and can only discover a proxy server by using the following discovery methods:If you're using Transparent proxy or WPAD in your network topology, you don't need special configuration settings. Enable access to Microsoft Defender ATP service URLs in the proxy server. b. Klicken Sie mit der rechten Maustaste auf Eingabeaufforderung, und wählen Sie Als Administrator ausführen aus. Par exemple: netsh winhttp définit le proxy 10.0.0.6:8080 For example: netsh winhttp set proxy 10.0.0.6:8080.
Pour réinitialiser le proxy WinHTTP, entrez la commande suivante et appuyez sur entrée. It's recommended you move to DNS resolving setting.Verify the proxy configuration completed successfully, that WinHTTP can discover and communicate through the proxy server in your environment, and that the proxy server allows traffic to the Microsoft Defender ATP service URLs.Extract the contents of MDATPClientAnalyzer.zip on the device.If at least one of the connectivity options returns a (200) status, then the Microsoft Defender ATP client can communicate with the tested URL properly using this connectivity method.
These settings can be overridden on a per-request basis. netsh winhttp reset proxy Pour en savoir plus, voir syntaxe de commande netsh, contextes et mise en forme.